ENGLISH
48
• Close the door, switch on the appliance;
• Within 60 seconds after the appliance
was switched on press the program or
more than 5 seconds to enter the water
softener setting mode.
• Press the program button again to select
the proper set according to your local
environment, the setting will change
in the following sequence: H1->H2->H3-
>H4->H5->H6;
• Press “Encendido” button to end the
setting mode.
The dishwasher is programmed from the
factory with hardness H3.
Every cycle with a regeneration operation
consumes additional 2.0 litres of water,
the energy consumption increases by
0.02 kWh and the program extents by 4
minutes.
Note: If your model does not have any
water softener, you may skip this section.
The hardness of the water varies from
place to place. If hard water is used in
the dishwasher, deposits will form on the
dishes and utensils.
The appliance is equipped with a special
softener that uses a salt container
specically designed to eliminate lime and
minerals from the water.
Loading the salt into the softener
• If your model does not have any water
softener, you may skip this section.
• Always use salt intended for
dishwasher use.
• The salt container is located beneath
the lower basket and should be lled as
explained in the following:
• Only use salt specically designed
for dishwashers use: Every other
type of salt not specically designed
for dishwasher use, especially table
salt, will damage the water softener.
In case of damages caused by the use
of unsuitable salt the manufacturer
does not give any warranty nor is
liable for any damages caused.
• Only ll with salt before running a
cycle: This will prevent any grains
of salt or salty water, which may
have been spilled, remaining on the
bottom of the machine for any period
of time, which may cause corrosion.
Please follow the steps below for adding
dishwasher salt (see image 09 on page 6):
• Remove the lower basket and unscrew
the reservoir cap.
• Place the end of the funnel (if supplied)
into the hole and pour in about 1.5 kg of
dishwasher salt.
• Fill the salt container to its maximum
limit with water, It is normal for a small
amount of water to come out of the salt
container.
• After lling the container, screw back
the cap tightly.
• The salt warning light will turn off after
the salt container has been lled with
salt.
Immediately after lling the salt into the
salt container, a washing program should
be started (We suggest to use a short
program). Otherwise the lter system,
pump or other important parts of the
machine may be damaged by salty water.
This is out of warranty.
Note: The salt container must only be
relled when the salt warning light in
the control panel comes on. Depending
on how well the salt dissolves, the salt
warning light may still be on even though
the salt container is lled. If there is no
salt warning light in the control panel (for
some models), you can estimate when to
ll the salt into the softener by the cycles
that the dishwasher has run.
Note: If salt has spilled, run a soak or quick
program to remove it.
Loading rinse and detergent
The rinse aid is released during the nal
rinse to prevent water from forming
droplets on your dishes, which can leave
spots and streaks. It also improves drying
by allowing water to roll off the dishes.
To Next Page
Loading...