EN
49
Your dishwasher is designed to use liquid
rinse aids.
Unless the rinse-aid warning light ( )
on the control panel is on, you can always
estimate the amount from the color of the
optical level indicator located next to the
cap.
When the rinse-aid container is full, the
indicator will be fully dark. The size of
the dark dot decreases as the rinseaid
diminishes. You should never let the rinse
aid level be less than 1/4 full (see image 10
on page 7).
34. Rinse aid tank
35. Full
36. 1/2
37. 3/4
38. 1/4
39. Empty
Only use branded rinse aid for
dishwasher. Never ll the rinse
aid dispenser with any other
substances (e.g. Dishwasher
cleaning agent, liquid
detergent). This would damage the
appliance.
Filling the rinse aid reservoir (see image 11
on page 7)
40. Remove the rinse reservoir cap by
rotating it counterclockwise.
41. Carefully pour in the rinse-aid into
its dispenser, whilst avoiding it to
overow.
42. Close the rinse aid reservoir cap by
rotating it clockwise.
Adjusting the rinse aid reservoir
Turn the rinse aid indicator dial to a
number between 1 and 6. The higher the
number, the more rinse aid the dishwasher
uses. If the dishes are not drying properly
or are spotted, adjust the dial to the next
higher number until your dishes are spot-
free. Reduce it if there are sticky whitish
stains on your dishes or a bluish lm on
glassware or knife blades.
Function of detergent
The chemical ingredients that compose the
detergent are necessary to remove, crush
and dispense all dirt out of the dishwasher.
Most of the commercial quality detergents
are suitable for this purpose.
Filling the detergent dispenser
Be aware that depending on the soiling
of water, setting may be different.
Please observe the manufacturer’s
recommendations on the detergent
packaging (see image 12 on page 7).
43. Press the release catch on the
detergent 2 dispenser to open the
cover.
44. Add detergent into the larger
cavity (A) for the main wash cycle. For
more heavily soiled wash loads, also
add some detergent into the smaller
cavity (B) for the pre-wash cycle.
45. Close the cover and press on it
until it locks into place.
Note: Be aware that depending on the
soiling of water, setting may be different.
Note: Please observe the manufacturer’s
recommendations on the detergent
packaging.
LOADING THE DISHWASHER BASKETS
ACCORDING TO EN60436: Loading the
dishwasher to its full capacity will
contribute to energy and water savings.
Loading the household dishwasher to the
capacity indicated by the manufacturer
will contribute to save energy.
• Use only glassware and porcelain
dishes provided by the manufacturer
with the “Dishwasher Resistant” label.
• Use a detergent characterized as “mild”
or “non-aggressive”.
• Remove the glassware and cutlery as
soon as possible after completion of the
washing programme in order to avoid
damage to them.
Instructions before loading baskets
Scrape off any large amount of leftover
To Next Page
Loading...