universalblue JAVA 6045DX - Page 14

TABLAS · TABLES · TABELAS ·
14
Problem Solution
Dishwasher does not drain water Check the lter, it may be blocked.
Check pipe connections, this could be an installation fault.
Dishwasher water leakage
problem
Check pipe connections, this could be an installation fault.
Check the water inlet and outlet pipes, they may be leaking.
There is foam in the dishwasher A non dishwasher-safe detergent may have been used. Pour
a litre of water into the machine, close the lid and set the
machine on a fast cycle. The soap should dissolve and drain
with the water.
The dishwasher is dirty You may have loaded utensils with a large amount of
encrusted food. Drain the dishwasher and remove this dirt
with a cloth and the machine's own detergent.
A white lm is visible on the
bottom of the dishwasher.
If the water contains large amounts of salt or lime, deposits
may form on the bottom of the dishwasher. Drain the
dishwasher and remove this dirt with a cloth and the
dishwasher's own detergent.
The dishwasher does not clean
properly
Utilice una cantidad correcta de detergente. Use correct
amount of dish soap.
It is possible that some of the elements may cover other
elements and make them difcult to clean.
Fill the appliance correctly; incorrect positioning or too
many utensils makes cleaning difcult.
Utensils have scratches/white
marks
The water in your area may be too hard. Reduce the amount
of dish soap.
Check that there is enough salt in the salt tank and rell it.
Dishwasher makes noise inside
the machine
Some utensils may be blocking the movement of the blades.
Position the utensils correctly
Check that nothing has fallen to the bottom. Wear gloves
when removing them as the water temperature may be high.
Problema Solução
Lava-louças não liga Verique se o cabo está conectado à rede.
Verique se a corrente voltou após a instalação do aparelho.
A máquina de lavar loiça não
inicia a limpeza
A porta deve estar fechada para que o programa comece.
O lava-louças não bebe a água Verique as conexões dos condutos, pode ser uma falha de
instalação.
Comprove que a toma de água está aberta.