universalblue MELIDE 4020X - Page 24

ENGLISH
24
2. Display.
3. Tie down point.
4. On/Off switch.
5. Reset button.
To see the product characteristics see
table 01 on page 7.
ASSEMBLY AND INSTALLATION
This product does not require complicated
installation and assembly processes.
Before unpacking the product, memorize
the position in which each accessory is
located, in case it is necessary to pack it
again in the future.
Remove all packaging material,
labels and/or stickers from
your product. Make sure that
no packing material is left
inside, as it may cause damage
or re.
• If the product has been damaged, please
contact the retailer from whom it was
purchased.
• The manufacturer cannot be held
responsible for damage to the product
caused by incorrect installation.
Follow the steps below to install the
product:
• Place the unit on a smooth wall.
• The unit must be correctly positioned
on the wall with the minimum
dimensions established for the correct
operation of the unit (see picture 3 on
page 4).
• The appliance is ready to be tied dowm
to the wall. To do this, drill two holes in
the wall at a specied distance and in a
specied position, as shown in picure 4
on page 5. Make sure that the holes are
the same size as the plugs and screws
Ensure that there are no
electrical cables or other
installations near the holes.
•
• Drive the plugs into the holes and insert
the screws. They should be positioned
as shown in picure 5 on page 5 so that
the unit can be hung in the correct
position later.
• The ventilation and exhaust slots must
be uncovered.
• The unit is supplied ready for
connection to a properly installed and
earthed socket.
For your safety, please note that:
• Relocation of the socket or replacement
of the connection cable must only be
carried out by a qualied electrician..
• The socket on the unit must always be
accessible.
• Do not use multiple socket strips or
extension cords as this may cause
overload
Make sure the appliance is
securely and vertically
attached to the wall.
USING THE APPLIANCE
• This device is easy to use and does not
require extensive knowledge. Please
familiarize yourself with your product
before rst use.
• This appliance has been designed for
domestic use only.
• Never use the appliance for purposes
other than those for which it has been
designed.
• The device must not be used by
children, nor by people who do not have
the knowledge of how to use it correctly.
• Once correctly installed on the wall
according to the indications, the
appliance is ready to use.
• Plug the cable into a 220-240V power
outlet. The appliance will play a sound,
the power light will illuminate and the
stove will display the room temperature.
• This product is also bluetooth and Wi-
Fi enabled and can be controlled via
an app. The connection procedure and
the functions of the application are