EN
25
explained in the Wi manual supplied
with this product.
Remote control functions (see image 6 on
page 5):
6. On/Off. Turns the unit on and off.
Please note that during the rst few
seconds, air at room temperature
will come out. Similarly, when the
appliance is switched off, air at room
temperature is blown out for 30
seconds to cool the appliance.
7. Mode. Press once to start hot air
output at medium power (1000W) and
a second time for maximum power
(2000W). Press a third time for room
temperature air.
8. Auto. Intelligent energy saving
programme. The appliance senses
the room temperature and operates in
oscillating mode. If the temperature
drops by more than 3ºC in one minute,
the appliance switches off since it
recognises that there is a window,
door, etc. through which the heat is
escaping.
9. Reduce. Set (-) the thermostat between
10ºC and 49ºC.
• If the air temperature falls 2ºC below
the set temperature, the heater starts
to heat at 1000W. If it falls 4 degrees
below the set temperature, the heater
will start heating at 2000W. If the air
temperature is higher than 1 degree
or lower/equal to the set temperature,
the heater will blow cold air.
10. Timer. Timer setting up to 24 hours.
Press and hold to increase the hours
from 0 to 24. A setting of 0 hours does
not correspond to a time setting.
11. Lock. Press and the heater light goes
out (except for the power light), the
child lock function is activated. Press
again and the heater light comes on,
the child lock function is cancelled.
12. Oscillating. Distributes the air with a
slight movement.
13. Increase. Adjust (+) thermostat setting
between 10ºC and 49ºC.
• When the air temperature drops 2ºC
below the set temperature, the heater
starts heating at 1000W. If it falls 4
degrees below the set temperature,
the heater will start heating at 2000W.
If the air temperature is higher than
1 degree or lower/equal to the set
temperature, the heater will blow cold
air.
Display (see image 7 on page 6):
14. Fan/cooling mode indicator.
15. Power input to the appliance indicator.
16. Power on indicator.
17. Off indicator.
18. Oscillation indicator.
19. Timer indicator.
20. 1000W mode indicator.
21. 2000W mode indicator.
22. Display. Temperature and time
display.
23. Auto mode indicator.
24. No function.
CLEANING AND MAINTENANCE
This product does not require great care,
although a series of basic rules must be
taken into account for its maintenance:
• Before cleaning or maintaining the
appliance, disconnect it from the mains.
• For cleaning it is recommended to use a
soft, damp cloth and a neutral detergent.
• Do not use an abrasive cloth or devices
that may affect the appearance of the
appliance.
• Check that the hot air outlet and
ventilation inlet are free of dust and
dirt.
• During cleaning, be careful not to touch
the resistors.
In the event of a breakdown or malfunction
of the appliance, disconnect it from
the electrical network and contact our
technical service.
ERP TABLE
See table 03 on page 9.
To Next Page
Loading...
