Need help?Do you have a question about the UNV DMC8000 and is the answer not in the manual?
Contains notices, environmental protection, audience, and general safety precautions.
Details safety symbols, warnings, and cautions for equipment handling.
Outlines FCC, LVD/EMC, WEEE, and Battery Directives compliance for the device.
Introduces the video wall controller, its functions, and notes on appearance variations.
Illustrates front and rear views of devices, labeling key components and ports.
Details the control board's interfaces, indicators, and reset functions.
Describes the VGA video input board's interfaces, indicators, and reset functions.
Describes the DVI video input board's interfaces, indicators, and reset functions.
Describes the HDMI video input board's interfaces, indicators, and reset functions.
Describes the DVI video output board's interfaces, indicators, and reset functions.
Lists default network parameters like IP address, subnet mask, and gateway.
Verification of device components, tools, and installation site requirements.
Guidance on installing the device in cabinets or on workbenches, including grounding.
Step-by-step instructions for installing service boards, control boards, and power modules.
Correct methods for powering the device on and off, including important cautions.
Instructions for accessing and logging into the device's web interface.
General| Model | DMC8000 |
|---|---|
| Type | Controller |
| Network Protocols | HTTP, HTTPS, RTSP, RTCP, DHCP, DNS, DDNS, UPnP, SMTP, SNMP, 802.1x, QoS, IPv4, IPv6 |
| Power Supply | 100-240V AC, 50/60Hz |
| Operating Temperature | -10°C ~ +55°C (14°F ~ 131°F) |
| Hard Disk | 8 SATA interfaces, up to 10TB for each HDD |
| RAID | RAID 0, 1, 5, 10 |
| Network Interface | 2 x RJ45 10M/100M/1000M adaptive Ethernet ports |
| Operating System | Linux |
| Serial Ports | 1 x RS-232, 1 x RS-485 |
| USB Interface | Front panel: 2 × USB 2.0; Rear panel: 2 × USB 3.0 |
| USB Ports | Front panel: 2 × USB 2.0; Rear panel: 2 × USB 3.0 |
To Next Page