EGOI Permanent On Board Dual Motor
Air Compressor System 6.1 CFM
SET-UP & CARE INSTRUCTIONS
2
PRE-INSTALLATION PREPARATION:
The UpDownAir air compressor comes complete with all the instructions you will need to install your new air compressor.
However, UpDownAir recommends that you have your UpDownAir air compressor installed by a trained professional. If
using a vehicle specific mounting solution, make sure your air compressor kit is the correct model for your application.
Please be sure to read the complete installation guide and have access to and knowledge of all the necessary tools, parts,
and materials to complete the proper installation.
TOOLS NEEDED
*** IMPORTANT***
• Standard automotive sizes of sockets, wrenches, and drills (Metric and SAE)
• Cutting scissors or razor knife
• Multimeter or test light
• Thread sealant for pressure fitting (Teflon tape)
• Automotive crimp fitting or soldering tool to make electrical junctions
• Electrical tape or heat shrink tubing to insulate electrical junctions
• Mild soap and water to check for leaks
Please read the entire install guide prior to attempting installation or making any modifications to the compressor unit
or vehicle.
The UDA EGOI 2 series compressors can be used for several air applications including tire inflation, hand air tool
operation, air locker activation etc. Each of these compressed air applications have different outlet port connections.
If the compressor is only to be used for inflating a few tires rapidly then a hose coupling can be screwed directly into
the compressor outlet port. It is important to note that compressing air at a high rate produces a lot of heat. If using
for multiple tires or vehicles, the hose and coupler fitting on the compressor will get hot.
If the UDA EGOI 2 compressor is to be used for prolonged periods or plan and being used to power air tools, it is
recommended that the compressor be connected to a separate air tank. Running a separate air tank will dissipate the
heat from the compressed air and allow the compressor to run more efficiently.
Connecting the compressor to an incorrect voltage level will cause extensive damage to the compressor’s DC motor, so
carefully follow the power connection instructions to a reliable 12V power source.
To Next Page
Loading...