UP3D UP500 - Scanner Connection; Installation of Software

UP3D TECH CO.,LTD
9
1.2.2 Scanner Connection
（1）Connect USB cable of scanner to the computer's USB port；
（
2
）
Connect the power line to the power port of scanner
；
（3）Insert the UP3D dongle ;
（
4
）
Power on the scanner
；
Figure 1-2 Figure 1-3
1
）
The connection requires a ground wire to avoid damaging the internal
components of the scanner！
2
）
Please unplug the scanner when it’s thunderstorms!
1.3 Installation of Software
Installation steps vary depending on the hardware version of the scanner!