UPC 5600 - Step 4: Install Top Plate; Step 5: Assemble and Attach Header

Page 4 of 4
Without removing the Wire Assembly
Helper (E), install Top Plate (D), over slots
on top of Racks (F), and attach with
Screws (H).
Note: Do not remove helper.
NOTE: There are different header styles that are available, please follow the appropriate instructions.
Remove masking from the adhesive
strip on the underside of the Header
Clip (K). Place Header Clip (K) onto
the center of the Top Plate (D) and
insert signage into Header Clip (K).
Assemble Header (G) with Push
Clips (L). Set Header (G) into slots on
top of Top Plate (D).
A B
ASSEMBLY
4
5