OUTSIDE TYPE MODELS
Net Installation Instructions
STEP
1
INSERT THE NET TO THE POLES
Pull down each sleeve, a few inches at a time till all sleeves
reach the bottom of enclosure frame as shown in figure 2.
UBNET-7.5-6-OS
UBNET-10-8-OS
UBNET-12-4-OS
UBNET-12-6-OS
UBNET-13-6-OS
UBNET-13-8-OS
UBNET-14-6-OS
UBNET-14-8-OS
UBNET-15-6-OS
UBNET-15-8-OS
UBESOS138
UBESOS146
UBESOS148
UBESOS156
UBESOS158
Enclosure Sets
Enclosure Nets
UBESOS7.56
UBESOS108
UBESOS124
UBESOS126
UBESOS136
Connect bottom straps/clips to every few Jumping mat v-rings from under the Safety Pad.
Attach the clips from outside as figure shows.
STEP
2
CONNECT BOTTOM STRAPS
9
Start installing the Net to the poles by inserting the beginning
of the Sleeve on the Poles Until it reaches 2 ft. and continue
doing the same to all poles as figure 1.
Fig. 1
Fig. 2
To Next Page
Loading...
