20
Setting Printing Position Adjustment: right/left (0–9)
(code 03)
When you initially set up your clock, you may skip
this step. This setting can be changed later if you nd
that the printing alignment is off. If the alignment is
incorrect, you can adjust the position on the time
card where the punches will print. When the code
“03” appears, set the position (right/left) where the
punch will print. Use the + and – buttons to make
your selection, then press Enter to conrm the
setting.
NOTE: It is recommended that you leave this setting
at the default.
HN3—Alarm Options
The HN3000 allows you to set up to 12 alarms during
the week. You can set up alarms to signal the beginning
and end of shifts and the beginning and end of breaks.
At the designated time, the HN3000 will play the internal
alarm music or ring an external bell, which is purchased
separately.
Setting the Duration of the Alarm (code 00)
Under the HN3 menu, when the code “00” appears,
set the duration of the alarm time (in seconds). Use
the + and – buttons to make your selection, then
press Enter to conrm the setting.
Setting the Ringing Time from Group 01 to Group 12
(codes 01–12)
You can set up to 12 different times, or groups, for the
alarm/bell to ring during the work week. Each group
is numbered 01–12. You may not wish to use all 12
alarms. For example, if you only wish to set alarms for
the beginning and end of a lunch break, you will only
set up alarms for two groups.
To Next Page
Loading...
Need help?
General
