To Next Page

To Previous Page

1 No Pay Period—Select 01 for job tracking mode.

This means there is no pay period set and the

clock will punch in the row that correlates with

the current date.

2 Monthly—Select 02 for the Monthly option, then

select the date on which the pay period will start.

3 Weekly—Select 03 for the Weekly option, then

select the day on which the pay period will

start. Enter 00 for Sunday, 01 for Monday, 02 for

Tuesday, 03 for Wednesday, 04 for Thursday, 05

for Friday, or 06 for Saturday.

4 Bi-weekly—Select 04 for the Bi-weekly option,

then select the month and date on which the rst

pay period started. Enter 01 for January, 02 for

February, and so on.

5 Semi-monthly—Select 05 for the Semi-monthly

option, then select the rst payday. Enter 01 for

the paydays to fall on the 1st and 16th of the

month or enter 15 for the paydays to fall on the

15th and the last day of the month.

Use the + and – buttons to make your selection, then

press Enter to conrm the setting.

Setting Printing Position Adjustment: up/down (0–9)

(code 02)

When you initially set up your clock, you may skip

this step. This setting can be changed later if you nd

that the printing alignment is off. If the alignment is

incorrect, you can adjust the position on the time

card where the punches will print. When the code

“02” appears, set the position (up/down) where the

punch will print. Use the + and – buttons to make

your selection, then press Enter to conrm the

setting.

NOTE: It is recommended that you leave this setting

at the default.

uPunch HN2000 User Manual

Questions and Answers: