URBANGLIDE MANUEL D'UTILISATION ECROSS PRO BOOST - Maintenance and Settings; Lubrication and Brake Adjustment; System Configuration Options; Error Code Troubleshooting

28
Maintenance
Lubrification
The folding system of your scooter needs to be lubricated every 6 months with a neutral
non-corrosive oil.
Brake
When your brake performance begins to decline, you can adjust the
sensitivity of your brake cables.
System settings
To enter your product settings, press the "+" and "-" buttons on your screen for 5 seconds.
Warning ! If you change all the basic settings, you will change the performance and status of your product. You
are advised to change only the settings below :
Menu
Settings
P01
Brightness adjustment
P02
Setting the distance measurement unit
0 = KM 1=MILES
P04
Screen saving time
0 = No sleep mode 1 to 60 = The number of minutes of standby time
P09
Startup mode
0 = Immediate start 1 = Impulse to start
Error codes
ERROR
PROBLEMS
E06
Battery
Check that your battery is fully charged. If so, check that the battery compartment (tray) is not damaged. Then check the
condition of your product's cables.
E07
Motor
Check the condition of the cables of your product. Then check the condition of the motor(s).
E08
Accelerator
Check that the throttle trigger is in good condition. Check the condition of your product's cables.
E09
Motherboard
Check the condition of your product's cables. Change the motherboard.
E10
Receiving cable
Lost signal, check the condition of your product's cables. This problem may come from the motherboard or the screen.
E11
Transmitter cable
Lost signal, check the condition of your product's cables. This problem may come from the screen.
E30
Communication error
Go to the settings of your product by pressing and holding the "+" and "-" buttons. Go to the P20 setting and enter 0.