urmet domus IPerCom - Connect Installer USB Drive; Update System Firmware; Configure System; System Testing and Commissioning

2019 ©
Browse to the folder named
IPerCom tools.
Open the document titled
IPerUpgrade tool user guide.
Follow this guide to update the system
devices to the latest firmware.
Browse to the folder named
IPerCom tools.
Open the document titled
IPerCom Installer tool user guide.
Follow this guide to configure the system.
Note - Configuration of the following products and
features is covered in the IperCom Installer tool -
Advanced user guide;
1060/84 Special Decoder
1060/74 Entry Panel
RTSP Camera set up
Proximity Access Control set up
Call Forwarding
PC Switchboard setup and lift control are
covered in separate guides on the Installer
USB flash drive.
Test and commission the system.
Commissioning Test Result sheets
are provided on the Installer USB
flash drive.
Pass the Client USB flash drive to the
customer. It contains all End User
information including O & M manuals and
user instructions.
Connect the Installer USB
flash drive supplied with the
IPerCom Installation Pack to
your PC or laptop.
IPerCom
IPerCom
IPerCom
Installer
Installer
tool
tool
-
user guide
user guide
user guide
www.urmet.co.uk
technical@urmet.co.uk
www.urmet.co.uk
technical@urmet.co.uk
www.urmet.co.uk
technical@urmet.co.uk
IPer
Upgrade manual
www.urmet.co.uk
technical@urmet.co.uk
DEMO
2
3
4
5
6
1
2
3
4
5
6
7
8
0
9
OK
ABC
GHI
JKL
MNO
QRS
TUV
WXYZ