History member data
1. Press
key to choose history member data
mode.
2. Hold on to press
can delete the current
history data.
3. Continue to press
, los últimos 20 grupos
de mediciones serán mostrados sucesivamente
en la pantalla LCD.
4. Press
key to exit the history record sta-
te, the tool will return the single measurement
mode.
MANTENANCE
This digital laser distance meter has been de-
signed to be a low-maintenance tool. Howe-
ver, in order to maintain its performance, you
must always follow these simple directions.
1. Always handle the tool with care. Treat it as
an optical device, such as a camera or binoculars.
2. Avoid exposing the tool to shock, continuous
vibration or extreme hot or cold temperature.
3. Always store the tool indoors,when not in use.
Always store the tool in its protective case.
4. Always keep the tool free of dust and li-
quids. Use only a clean, soft cloth for cleaning.
If necessary, slightly moisten the cloths with
pure alcohol or a little water.
5. Do not touch the lens with your ngers.
6. Check the batteries regularly to avoid dete-
rioration.
Always remove the batteries from the tool, if it
is not going to be used for an extended period
of time.
7. Replace the batteries when the battery icon
is continuously empty displayed on the LCD.
8. Do not disassemble the laser; this will expose
the user to hazardous radiation exposure.
9. Do not attempt to change any part of the
laser lens.
TROUBLESHOOTING
The following error signals may appear on the
LCD of your tool during measuring:
ERROR
CODE
ERROR
CAUSE
SOLUTION
ERR01
The reflected
laser light is
too intense.
Do not direct
the laser at
a highly
reflective sur-
face; cover the
surface with
white paper if
necessary.
ERR02
Out of range,
the measuring
range for this
tool is from
0.05-60m
Take measu-
rement within
the range of
0.05-60m.
ERR03
The target
provides poor
reflection of
the laser.
Change the
measuring tar-
get or cover it
with a piece of
white paper.
ERR06
Low battery
a reminder to
replace the
batteries.
Insert new
batteries.
Tool cannot be switched on
incorrectly
Reinstall the batteries
according to the polarity
indicators in the battery
compartment
Batteries are low voltage
Replaced with new batteries
The Power did not contact
well
Try to press it with a bigger
force of send for repair
The tool emits “click” when
tale a measurement
It is the shift of optical path
inside, normal
measuring
Please refer to the part of
“Error signals” above
Please refer to the part of
“Error signals” above
18
To Next Page
Loading...