3.5
Insert the quick release rod
from the opposite side of the
front disc into the hub.
3.6
Tighten the quick release cap and lock the quick release rod.
Adjust the position of the front wheel and handlebar to make sure they
are aligned and centered. Use a 5mm hex wrench to tighten the stem
screws with a torque of 8-9N·m.
3.7
5mm Hex Wrench
8-9N·m
3.4
Remove the quick release rod from
the accessory box, open the quick
release cap and adjust the spring
so that the large head faces out
and the small head faces in.
1
1
2
2
13
To Next Page
Loading...