声明：本说明书著作权归青岛欣易云联电子科技有限公司所有，未经允许任何单位或个人不得用于商业用途。
corresponding gear can be selected by pressing the "up / down" key Adjust the voltage;
Press and hold the "set" key to exit the active selection.
In PPS mode of PD protocol, press "set" to select step unit (1V / 100mV / 20mV) to select
step unit, and then modify the voltage through "up / down"; if you want to switch to other
voltage modes at this time, press "set" to select "gear" to switch to other gears through
"up / down";
Note: when the protocol is activated, please do not connect the output terminal with USB
device, so as not to cause activation failure;
Please follow the prompts when activating PD;
There are many different manufacturers of charging head on the market. This product can
not guarantee 100% support for activation.
System parameter setting interface:
Press the "set" key briefly to select / switch the parameter to be set. After selection, the
parameter will be displayed in reverse green, and the parameter will be set by pressing the
"up / down" key;
After setting, long press the "set" button for 2 seconds or more, and no key operation will
automatically exit the setting;
All parameters are saved automatically after exiting.
Night mode setting screen rest time: it can be set to rest screen after 1-9 minutes, and
wake up with any key.
To Next Page
Loading...