声明：本说明书著作权归青岛欣易云联电子科技有限公司所有，未经允许任何单位或个人不得用于商业用途。
USB power system (per)
Main power interface:
Press the "set" key briefly to activate the parameter to be set (voltage / current);
Short press "set" key to switch between full selection and bit selection;
When all is selected, the blue display will be reversed, and the set voltage / current will be
switched through the "up / down" button;
After the bit is selected, the corresponding bit will be displayed in reverse blue, and the
parameter can be set by pressing the "up / down" key. The "up / down" key supports long
press, and long press can quickly increase / decrease the parameter;
After setting, long press the "set" button for 2 seconds or more, and no key operation will
automatically exit the setting;
All parameters are saved automatically after exiting.
To Next Page
Loading...