Dimensions
Power source:
Current (OPERATE mode – standby):
Current (OPERATE mode – dialing):
Activation:
Max. digits for outgoing numbers:
Operating temperature range:
Dimensions (inches):
Weight (ounces):
Mounting:
Case Material:
Color:
Warranty:
9-18VDC
28mA typical.
100mA max.
1) N.C. Activation: dialer activates when an “open” is detected
2) N.O. Activation: dialer activates when a “close” is detected
3) Voltage Activation: N.C. (applied voltage: Min. +5VDC, Max. +28VDC)
N.O. (loss of continuous voltage: Min. 0VDC, Max. 0.25VDC)
50
-18 to 55 C (0 to 130 F)
6 x 4 x 1.5 in
10 oz
Wall or Flat Surface
ABS
White
1 Year
Note: Design and specifications subject to change without notice.
Power Source
AC-1: AC/DC Adaptor
Plugs into regular 110VAC outlet to provide the dialer with the
required primary power.
AC-2: AC/DC Adaptor
12VDC/0.5A for stand alone with siren use.
PP-1: Power (Rechargeable)
Provides 24 (est.) hours of backup standby power.
AC-1P: AC/DC Adaptor For Use With PP-1
Plugs into regular 110VAC outlet to provide the dialer with the
required primary power and additional input for PP-1 interface.
IR-1: Isolation Relay
Converts alarm output voltage to N.C. to provide clean input
trigger to dialer.
Industrial/Residential Sensors
F20: Temperature Supervisory Switch <40 F
HTS: High Temperature Switch
LTS: Low Temperature Switch
CSS: Cold Storage Switch
WLS: Water Level Sensor
RTS: Adjustable Temperature Controller, N.O., N.C.
PLS: Power Loss Sensor (110VAC)
Sensors
Magnetic Contacts – Door and Window
Glass Break Detectors
Hold Up Buttons/Emergency Switches
Pressure Mats – Sealed and Under Carpet
Motion Detectors
Siren
S-120: 2” Mini Siren, 12VDC @ 120 mA typical
Additional Options
Data logger: AD-2001-DL
Retains in memory log of alarm events for later retrieval and
review.
Wireless: AD-2000/W
Wireless version AD-2000 dialer includes wireless pendant
transmitter.
24V Application: AD-2000/F
For this option the dialer is configured to operate at 24VDC to
32VDC max. All other specifications apply.
Wireless and 24V Applications: AD-2000/W/F
The AD-2000/W/F incorporates both the wireless feature and
24VDC application. See WIRELESS AND 24V APPLICATION
for further details.
NOTE: CALL UNITED SECURITY PRODUCTS FOR
ADDITIONAL INFORMATION AND DEVICES NOT LISTED
HERE.
Wireless Upgrade:
The standard AD-2000 can be upgraded for wireless link-up with
RF-activated mag contacts, motion sensors, pendant, etc., by
installing a new back cover containing a pre-tested RF assembly
and swivel antenna. The receiver is connected to the main board
via a 4-pin interface connector already included in the standard
configuration. See WIRELESS for further details.
NOTE: SYSTEMS ALREADY INSTALLED CAN BE
UPGRADED WITHOUT REPLACING OR RE-WIRING THE
DIALER.
To Next Page
Loading...