To Next PageTo Next Page
Need help?Do you have a question about the USSC 4027 and is the answer not in the manual?
General warnings regarding installation, fuel type, and smoke detectors.
Appliance compliance with UL safety standard 1482 by Warnock Hersey.
Lists essential materials for proper installation in a residential home.
Instructions for assembling the shaker handle.
Steps for attaching handles to feed and ash doors.
Procedure for mounting the flue collar to the heater top.
Details connecting via a 3-1/2" brick masonry wall with a fireclay liner.
Describes using a 6" diameter solid insulated factory-built chimney section.
Explains connecting with a 10" diameter ventilated thimble.
Outlines using an 8" diameter solid insulated factory-built chimney section.
Covers using a listed factory-built wall pass-through system.
Installing chimney inside the residence through ceiling and roof.
Installing chimney up the outside of the residence.
Details required clearances to walls and ceilings using Figure 8.
Explains using sheet metal or masonry for reduced clearances.
Heater must comply with Type 103-HT chimney standards.
Collect necessary items for heater installation.
Placing a floor protector on combustible floors.
Instructions for installing a chimney shield for protection.
Guidance on burning bituminous and anthracite coal.
Methods for starting and operating with bituminous coal.
Steps for starting and operating with anthracite coal.
Best practices for adding coal to the fire.
Techniques to boost heat output from a low fire.
Proper methods and frequency for shaking the grate.
How to adjust draft settings for heat output.
Handling and disposal of ashes to prevent damage.
How to identify and clean soot from the chimney.
General| Heating Capacity | 1, 800 sq ft |
|---|---|
| Fuel Type | Wood |
| Efficiency | 75% |
| Weight | 275 lbs |
| Dimensions | 27" H x 24" W x 22" D |
| Heating Area | 1, 800 sq ft |
