4141
3. Power Shift Transmission Fluid Level3. Power Shift Transmission Fluid Level
Open the inspections cover and remove the fillerOpen the inspections cover and remove the filler
cap. Inspect the lever gauge to make sure that the fluidcap. Inspect the lever gauge to make sure that the fluid
level is on the upper mark of the gauge.level is on the upper mark of the gauge.
4. Mast and Forks4. Mast and Forks
Check the mast and forks to make sure:Check the mast and forks to make sure:
（（
11
））
There is no crack and bend on the forks, and theThere is no crack and bend on the forks, and the
forks are installed on the fork bracket strongly.forks are installed on the fork bracket strongly.
（（
22
））
Check if Check if there is there is oil leakage oil leakage on the on the cylinder orcylinder or
tubing.tubing.
（（
33
））
Check the rollers‘ rotation.Check the rollers‘ rotation.
（（
44
））
Check the mast for cracks or bends.Check the mast for cracks or bends.
（（
55
））
Operate the lever for lifting, tilting andOperate the lever for lifting, tilting and
attachment. attachment. Check the overall Check the overall condition of condition of the mast.the mast.
5. Lift Chain Tension Check5. Lift Chain Tension Check
（（
11
））
Raise the fork about 10Raise the fork about 10--15 cm above the ground15 cm above the ground
and make it vertical.and make it vertical.
（（
22
））
Press middle of the chain by thumb. MakePress middle of the chain by thumb. Make
certain the tension for the right and left chains arecertain the tension for the right and left chains are
even.even.
（（
33
））
Adjust the tension: Loosen the lock nut 1, screwAdjust the tension: Loosen the lock nut 1, screw
the nut 2 and adjust the chain to make the equalthe nut 2 and adjust the chain to make the equal
tension, turning the adjusting nut 1 of the chain anchortension, turning the adjusting nut 1 of the chain anchor
pin.pin.
To Next Page
Loading...
