Installation Guide
You & i-Line Wall-hung Wall Unit
Important Information
• Read the instructions carefully.
• Ensure product contents are complete.
• Check the product for any signs of damage and remove all protective film.
• It is recommended that a technically competent installer undertakes installation.
• It is the installer’s responsibility to carry out a thorough assessment of wall type and the
weight of the cabinet and use appropriate fixings.
• Care should be taken when drilling to avoid any hidden wires or pipes.
• To prevent the cabinet falling from the wall this product must be fixed using the wall
attachment device provided.
Installation
It may be necessary to snap the wall plate in half at the marked line
to create two wall brackets. Mark a horizontal line on the wall at the
required height X---X. Ensure that the wall brackets will fit inside the
width of the cabinet and are equally spaced to ensure even distribution
of weight. Secure the wall brackets to the wall using suitable fixings.
Hook the unit onto the wall brackets ensuring that the brackets are securely
Located.
To adjust the position of the cabinet on the wall, use the two screws in each
hanging bracket. The top screws will move the cabinet closer to or further
away from the wall. The lower screws will move the cabinet up and down.
Door hinge adjustment
To square the door against the cabinet, turn screws A until adjusted
as required.
To adjust the door closer to or further away from the cabinet, turn
screws B.
To adjust the door vertically, slacken screws C. Re-tighten once
the door is adjusted as required.
To remove the door hinges from the cabinet, press button D.
To remove the door hinges from the door, remove screws E.
Care & Maintenance
Furniture should be regularly dusted with a soft cotton or micro-fibre cloth. For more thorough
cleaning, occasionally wipe your furniture with a soft cloth dampened with a mild detergent
solution. Surfaces should be thoroughly dried with a lint free cloth to prevent watermarks. Under
no circumstances should solvent cleaning agents, bleach or abrasive cleaning agents or cloths be
used. Spills should be removed immediately using a clean cloth. All bathroom furniture will
deteriorate through prolonged periods of exposure to high levels of condensation so bathrooms
must be adequately ventilated using suitable extraction. Failure to ensure adequate ventilation
may invalidate your guarantee.
To Previous Page
Loading...