UW
Technics
#11075 Optoelectronic TTL-Converter (for SONY)
for NAUTICAM underwater photo housings
USER’S MANUAL
Specifications
! Compatible photo cameras: Sony A7 II, A7R II, A7S II, A7 R III, A7 III, A7R IV, A9
! Compatible underwater housings : NA-A7 II, NA-A7R III, NA-A7R IV, NA-A9
! Compatible strobes: Inon Z330, Z240, S2000,
Sea&Sea YS-250, YS-D1,
Sea&Sea YS-D2 (made-in-China)
Ikelite DS-161, DS-160,
Subtronic Pro-270, Pro-160.
! TTL outputs onboard: 2 optical, 1 electric
! (+/-) “Flash Exposure compensation” adjustment underwater: yes
! Continuous (serial) shooting mode support: yes
! 1-st / 2-nd curtain modes support: yes
! Switching TTL /M underwater by camera controls: yes
! Setting strobe power manually by camera controls in M mode: 1/64…..1/1
! Switching power “ON/OFF”: automatic by camera command
! Battery type: CR2032 (2pcs.)
! Current consumption (in standby mode) 0.01 mkA
! Battery capacity (+20°C): 1-3 years, 65 000 flashes
! Compatible Fiber-optic cable type: Nauticam #26216, #26217
! Available Electric Bulkhead type (optional accessory): Nikonos-5, Ikelite, S-6
! Dual Electric cables (“Sea&Sea”, “Ikelite”) support: yes
Safety Warning for Batteries usage
" Use batteries only CR2032 type.
" Batteries must be new and undamaged. Carefully check batteries before usage.
" To avoid leakage or explosion, always check appropriate battery terminals position (“plus” / “minus”) before installing to the
TTL-Converter.
" Never expose batteries to overheating, short-circuiting, disassembling, high pressure, mechanical deformation. Save
batteries from high humidity and water. All these circumstances may cause a chemical leakage, electric shock, explosion or
fire, which can be dangerous for health.
" Remove batteries from TTL-Converter before longtime storage.
" Utilize used batteries according appropriate rules.
" Keep out batteries of children. Save batteries in inaccessible for children place
To Next Page
Need help?
General
