V-Show B198 - System Calibration Procedures; System Reset Options

11
Automatic screen rotation function
The system can automatically rotate the screen according to the direction of gravity
without manual rotation. You can also turn off the automatic rotation function.
Manual control
This interface is used to control the current fixture.
Press the "OK" key to enter the editing state. Press the "up" and "down" keys to change
the channel value. Press "OK" again to save the modified value and exit the editing. Press
"Exit" to exit the editing without saving the modified value.
System calibration
Set a layer of password here to prevent misuse by non-professionals. Press the "OK"
button to verify the password
Reset
Press the "up" and "down" keys to switch the reset mode, and press "OK" to reset directly.
Option
Description
head
Reset effect panel except XY
XY
Only XY axis reset
all
Fixture reset
Option
Description
Initial position
calibration
After entering the sub-interface, you can adjust the reset
position of the X-axis, Y-axis and other motors to
compensate for the error in the hardware installation. The
adjustment range is 0~255, and 127 means no adjustment.
Stroke calibration
After entering the sub-interface, you can adjust the X-axis,
Y-axis and other motor strokes, the adjustment range is
0~255, 127 means no adjustment.
Force calibration
After entering the sub-interface, you can adjust the force of
the X-axis, Y-axis and other motors, the adjustment range is
0~255, 127 means no adjustment.
Speed calibration
After entering the sub-interface, you can adjust the speed of
the X-axis, Y-axis and other motors, the adjustment range is
0~255, 127 means no adjustment.
Fan control
Set control fan mode
Other calibration
Voice control sensitivity calibration, and change the
password
Advanced
calibration
Reserved function
Synchronization
Update
Select the above modification to update to other lamps and
lanterns simultaneously, "On" means to update the content