8
OPERATION
WARNING:
BE SURE TO READ, UNDERSTAND, AND APPLY ALL THE INFORMATION
IN THE IMPORTANT SAFETY INSTRUCTIONS SECTION AT THE BEGINNING OF THIS
OPERATOR'S MANUAL. DO NOT OPERATE IN AREAS WITH FLAMMABLE GASES,
VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE
BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASED
PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS. EXPLOSIVE DUSTS INCLUDE
BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR GUN POWDER. TO REDUCE
THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST, DO NOT USE AROUND TOXIC
MATERIALS.
1. Verify that the 3-speed on/off switch is set to "0" (OFF) and the cord is unplugged.
2. Place the air mover in the desired position on a stable surface. Ensure there is at least a foot of
clearance on each side of the air mover. Avoid placing the air mover where loose fabric, sheets,
or other objects can get pulled onto the intake grills.
3. Direct air mover at the designated target area, using one of the operational positions listed on
page 8.
4. Plug in the air mover to a grounded, GFCI-protected outlet. See page 4 for Grounding
Instructions.
DO NOT USE WITH AN EXTENSION CORD.
5. Turn on the air mover by rotating the 3-speed on/off switch clockwise to the desired power
level (I, II, or III).
6. The air mover is equipped with an overload protection feature. If the air mover is overloaded,
it will shut off and will need to be reset before it can be used again. If this occurs, rst remove
any power tool or other devices from the power receptacle. Then set the 3-speed on/off switch
to "0" (OFF) and press the reset button. Check that there are no obstructions preventing airow
into the intake grills before turning on the air mover again.
7. When nished with use, turn the 3-speed on/off switch counter-clockwise to the "0" (OFF)
position and unplug the power cord from the outlet. See page 10-11 for storage instructions.
Carpet and Flooring Stairs and Walls Ceilings
GENERAL USE INSTRUCTIONS
OPERATIONAL POSITIONS
To Next Page
Loading...
