11
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 5)
3. Allow filter to air dry before installing and using again.
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE TROUBLESHOOTING
Symptom Possible Causes Corrective Action
Vacuum will not operate 1) No power supply. 1) Check power supply – cord,
breakers, fuses.
2) Faulty power cord. 2) Unplug and check the power
cord. If damaged, have it repaired
by a professional.
3) Container full. 3) Empty container.
Dust comes from motor cover. 1) The reusable cloth filter is missing
or damaged.
1) Attach or replace the reusable
cloth filter.
Reduced efficiency and
motor/speed vibration.
1) There is a blockage in the nozzle,
hose, or the vacuum inlets. Or the
dust filter is blocked by fine dust.
1) Check nozzle, hose and
container inlets for blockage. Take
off the filter and clean it. Or install
new filter.
TROUBLESHOOTING
To Next Page
Loading...
