EN
USING YOUR VACTIDY APPLIANCE
OPERATION
PLEASE READ THE'IMPORTANT SAFETY INSTRUCTIONS' IN THIS VACTIDY INSTRUCTION MANUAL BEFORE
PROCEEDING
• Do not use outdoors or on wet surfaces or to
vacuum water or other liquids ‒ electric shock
could occur.
• Ensure the appliance remains upright in use and
in storage. Dirt and debris may be released if it is
turned upside down.
• Do not operate while checking for blockages.
• For domestic indoor and car use only. Do not
use it while the car is in motion or while driving.
• This product has carbon fibre brushes. Take care
if coming into contact with them, as they may
cause minor skin irritation. Wash your hands
after handling the brushes.
VACUUMING
•Do not use without the dust container and filter
in place.
•Fine dirt such as flour should only be vacuumed
in very small amounts.
•Do not use the appliance to pick up sharp hard
objects, small toys, pins, paper clips, etc. They
may damage the appliance.
•When vacuuming, certain carpets may generate
small static charges in the clear bin or wand.
These are harmless and are not associated with
the mains electricity supply. To minimise any
effect from this, do not put your hand or insert
any object into the dust container unless you
have first emptied it. Clean the dust container
with a damp cloth only. (See 'Cleaning the dust
container' .)
•Use extra care when cleaning on stairs.
•Do not rest the appliance on chairs, tables, etc.
•Do not press down on the nozzle with excessive
force when using the appliance as this may
cause damage.
•Do not leave the floor brush in one place on
delicate floors.
•On waxed floors the movement of the floor
brush may create an uneven lustre. If this
happens, wipe with a damp cloth, polish the
area with wax, and wait for it to dry.
CARPETS OR HARD FLOORS
•Before vacuuming your flooring, rugs and
carpets, check the manufacturer's recommended
cleaning instructions.
•The brush bar on the appliance can damage
certain carpet types and floors.Some carpets will
fuzz if a rotating brush bar is used when vacuum-
ing. If this happens, we recommend vacuuming
without the motorised floor tool and consulting
with your flooring manufacturer.
•Before vacuuming highly polished floors, such as
wood or lino, first check that the underside of the
floor tool and its brushes are free from foreign
objects that could cause marking.
LOOKING AFTER YOUR VACTIDY APPLIANCE
•Do not carry out any maintenance or repair work
other than that shown in this Vactidy Instruction
Manual, or advised by the Vactidy Helpline.
•Only use parts recommended by Vactidy. If you
do not this could invalidate your guarantee.
•Store the appliance indoors. Do not use or store it
below 3°C (37.4°F). Ensure the appliance is at
room temperature before operating.
•Clean the appliance only with a dry cloth. Do not
use any lubricants, cleaning agents, polishes or
air fresheners on any part of the appliance.
EMPTYING THE DUST CONTAINER
•Empty as soon as the dirt reaches the level of the
Dust bin mark ‒ do not overfill.
•Ensure the appliance is disconnected from the
charger before emptying the
dust bin. Be careful not to pull the 'ON' trigger.
•To make emptying the dust bin easier, it is
advisable to remove the wand and floor tool.
•To release the dirt, push the blue button by the
dust bin: Press once to open the bin base.
•To minimise dust/allergen contact when
emptying, encase the dust bin tightly in a plastic
bag and empty.
•Remove the dust bin carefully from the bag.
•Seal the bag tightly, dispose as normal.
•Close the dust bin base so it clicks into place and
is secure.
WALL BRACKET INSTALLATION
Use appropriate mounting hardware for your wall
type and ensure that the docking station is mounted
securely. Ensure no pipe work (gas, water, air) or
electrical cables, wires or ductwork are located
directly behind the mounting area. The docking
station must be mounted in accordance with
regulations and applicable codes/standards (state
and local laws may apply). Vactidy recommends
the use of protective clothing, eyeware and
materials when installing the docking station.
01 02 03 04 05
06 07 08 09 10
11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 31 32 33
34 35 36 37 38 39 40
To Next Page
Loading...