VacuMaid GV30 - Operating Your VacuMaid System; Vacuuming Procedure; Using Vacuum Attachments and Tools

Vacuuming
Inserting the hose
The hose connects to the system through the utility valve
inlet on the front of the unit by lifting the round door
open and inserting the hose. (Fig. 1)
See below for using your attachments & cleaning tools.
On/O Switch
Insert the hose before turning the unit on.
The system is turned on and o by ipping
the switch on the side of the unit.
USING YOUR SYSTEM
6
1
USING YOUR ATTACHMENTS & CLEANING TOOLS
CLEANING TOOLS
All cleaning tools will attach to either
the hose cu or the telescopic wand by
pushing rmly onto the end.
a) Upholstery Tool
Works well for cleaning
car upholstery & carpet.
b) Crevice Tool
Reach into cracks and
crevices that are
hard to reach.
c) Dusting Brush
Use for dusting shelves,
tables, dashboards, etc.
Hose Hanger Loophoseonhanger
approx. 4-5 times or loop hose on oor and
then pick up and hang on hanger.
Telescopic Wand
Provides you extra length for oor
cleaning or reaching high areas.
To use: Adjust by a) twisting the ratcheting
mechanism in the middle of the wand to release
and extend. Twist back to tighten. b) Adjust by
pressing down on the ratcheting mechanism in
the middle of the wand to release and extend.
Floor Brush For cleaning light dirt & dust
on hard oor surfaces.
To use: Attach to telescopic
wand and go back and forth
over the area to be cleaned.
Do not force the front of
the brush down when moving forward. Allow the
brush to gently glide across the oor to pick up
larger debris.
(FT220 oor tool is recommended for larger debris. Sold separately)
a
b