Need help?Do you have a question about the Vaderstad Rapid RD 300-400C and is the answer not in the manual?
Adjusting seed drill depth using the push rod for consistent row depth.
Adjust radar angle to 35° ± 1° relative to the soil surface for optimal performance.
Use low-lift to minimize machine lift and ensure harrow operation on headlands.
Setting work pressure for mechanical following harrow based on soil conditions.
Depth adjustment of front tools using clips on the piston rod.
Adjust spill prevention plates vertically and horizontally to clear soil ridges.
Accessing the setup menu for machine configuration and settings.
Performing drive checks for machine operation and functionality.
Enabling half machine shut-off for precise area metering.
Configuring and managing tramlining cycles for efficient operation.
Monitoring seed amount and adjusting settings in the E-Control system.
Calibrating the seed delivery system for accurate sowing rates.
Settings and calibration for the fertiliser system.
Settings and calibration for the radar system.
Setting up and configuring tramlining programmes.
Using the MiniRemote for pre-filling feed rollers.
Filling calibration trays with grain using the ear button.
Inputting calibration data for pulse calculation.
Starting feed output from a stationary position or during verification.
Adjusting following harrow pressure for headlands and furrows.
Activating and deactivating low-lift function.
Setting and adjusting seed depth using the lifting ram.
Automatic progression of tramlining and bout marker switching.
Temporarily switching off feed output by pressing buttons.
Weighing calibrated seed sample.
Closing levers on seed hopper to perform half machine shut-off.
Halving area measurement by pressing the left Ear button.
General| Working Width | 3.0-4.0 m |
|---|---|
| Row Spacing | 12.5 cm |
| Number of Seed Coulters/Rows | 24-32 |
| Working Speed | 10-14 km/h |
| Transport Width | 3.0 m |
To Next Page
