Installation - riser rail
4 5
Installation - riser rail
Pull o the cover from the Holder.
Remove the nut, metal washer and
rubber washer from the bottom of the
threaded tube.
Insert the holder down through the
hole in the unit, make sure that the
rubber washer is against the top
surface.
From the underside slide the rubber
washer, metal washer and screw on the
nut (removed earlier) and tighten.
CAUTION: Do not over tighten the nut
as this may damage the unit.
Replace the cover.
Push the smaller end of the shower
hose down through the holder.
Nut
Metal washer
Rubber washer
Threaded tube
Rubber washer
Metal washer
Holder
Place a rubber washer into the cone
at the end of the hose and screw in
the handset.
Place the cone into the holder.
Connect the other end of the hose
to the supply, the unit comes with
an adaptor and washer if necessary.
Cover
Shower
hose
Cone
Shower
hose
Washer
Washer
Adaptor
Handset
Shower
hose
Holder
Cover
Water supply
To Previous Page
Loading...
