Troubleshooting
36
Operating and installation instructions 0020248967_00
8
7.4 Activating/deactivating the
operation lock
You can use the relevant room settings in
the VRC 700 app to activate and deacti-
vate the product‘s operation lock.
8 Troubleshooting
8.1 Command not confirmed
If at least one transceiver does not con-
firm a command, the signal LED lights up
red once the incorrect transmission is
completed.
The reason for the incorrect transmission
may be radio interference caused by one
of the following:
– Transceiver cannot be reached
– Transceiver cannot implement the com-
mand (load failure, mechanical block-
age, etc.)
– Defective transceiver
To Next Page
Loading...
