USER'S GUIDE____________________________________________________________________
10 __________________________________________________________________ M210843EN-C
Assembling the Antenna Set
One person can complete the antenna set assembly. When all the
cables are connected and you assemble the antenna set on firm
ground, the assembly takes less than two minutes.
NOTE
The antenna set is delivered with the Amplifier and Switch and the
cable holder assembled. If you disassemble these parts, you must
reassemble them to the exact locations in order for the antenna set to
fit in the transport case. The tripod legs contain small markings that
indicate the location for the top edge of the parts.
0704-015
Figure 2 CG31 Finger Nuts, Peg Hole and Cable Holder
The following numbers refer to Figure 2:
1 = Finger nut for GPS antenna
2 = Finger nut for Helix UHF antenna
3 = Cable holder
4 = Finger nut for locking ring
5 = Hole for peg
6 = Finger nut for tripod leg
To Next Page
Loading...