Chapter 3 _______________________________________________________________ Installation
VAISALA_______________________________________________________________________ 17
If the cables have been disconnected from the antennas and the
Antenna Amplifier and Switch, do the following:
1. Assemble the antenna set.
2. Run the dual antenna cable from the cable holder to the guide on
the tripod leg.
3. Connect the UHF antenna cables:
- Connect the UHF part of the dual antenna cable to the OUT
connector in the Antenna Amplifier and Switch.
0705-203
Figure 13 OUT Connector in the Antenna Amplifier
and Switch
- Connect the UHF antenna cable to the ANT1 connector in the
Antenna Amplifier and Switch.
0705-204
Figure 14 ANT1 Connector in the Antenna Amplifier
and Switch
To Next Page
Loading...