5 FR
Using the appliance
B
Before using your dishwasher
• Before using your dishwasher:
ExteriorInterior
SALT
1. Set the water softener
2. Load salt into the water softener
3. Load the rack
4. Fill the compartment
NOTE : Please refer to the “Water Softener” chapter if you need to adjust the water
softener.
Loading salt into the water softener
• Always use salt meant to be used in a dishwasher.
• The salt compartment is located underneath the bottom rack and must be lled following
the below instructions:
WARNING :
• Only use salt specifically designed for dishwashers!
Any other type of salt that is not specifically intended for use in a dishwasher, especially table
salt, will damage the water softener. In the event of damage caused by the use of unsuitable
salt, the manufacturer declines any warranty and any liability for the damage caused.
• Wait until you are ready to start a wash cycle before filling the salt tank.
This will prevent any grains of salt or salt water that may have been spilled and left on the
bottom of the machine for some time from causing corrosion.
To Next Page
Loading...
