6 FR
Using the appliance
B
• Follow the steps below to add regenerating salt:
SALT
1. Remove the bottom rack and unscrew the compartment cap.
2. Place the tip of the funnel (provided) into the hole and pour in about 1.5 kg of regenerating
salt.
3. Fill the salt compartment with water to the maximum limit. A small amount of water may
spill out of the compartment, which is normal.
4. After filling the compartment, screw the cap back on tightly.
5. The salt indicator light will turn off once the compartment is filled with salt.
6. Immediately after filling the salt compartment, a wash programme must be started. If not,
the filtration system, pump or other important parts of the machine may be damaged by the
salt water. This is not covered by the warranty.
NOTE :
• The salt compartment should only be lled with the salt indicator light ( ) turns on in the
control panel. Depending on how easily the salt dissolves, the salt indicator light may remain
on even though the compartment is full.
• CAUTION: Risk of corrosion and perforation of the tank or parts of the appliance
: If you spill any salt in the cavity during filling, please immediately rinse
the spot where the salt is spilt or start a wash programme.
Be especially careful when starting a programme with a delayed start.
To Next Page
Loading...
