13 FR
Using the appliance
B
A
B
2. Fasten the four long screws
1. Remove the four short screws
Step 3: Adjusting the door spring tension
1. The door springs are factory-set to the correct tension for the outer door. If you install the
decorative wooden panel, you will need to adjust the tension of the door springs. To do this,
turn the adjusting screw to tighten or loosen the steel cable.
2. The tension of the door springs is correct when the door remains horizontal in the fully
open position, but rises to the closed position with the touch of a finger.
Step 4. Steps to install the dishwasher
NOTE : Please refer to the installation steps described in the corresponding diagrams.
To Next Page
Loading...
