VALBERG 972793 - Wash Cycle Table

26 27
EN EN
Using the appliance Using the appliance
B B
Filling the detergent dispenser
1. Press the release latch on the detergent dispenser to open the cover.
2. Add detergent into the larger cavity
A
for the main wash cycle. For more heavily soiled
wash loads, also add some detergent into the smaller cavity
B
for release during pre-wash.
3. Close the cover and press on it until it locks into place.
NOTE
• Please observe the manufacturer’s recommendations on
the detergent packaging.
Wash cycle table
• The table below shows which programs are best for the levels of food residue on them and
how much detergent is needed. It also show various information about the programs.
• Consumption values and program duration are only indicative except for ECO program.
( ) indicates that the program uses rinse aid in the last rinse.
Program
Description of
cycle
Detergent
pre/main
wash
Running
time(min)
Energy
(kWh)
Water (L)
Rinse
aid
Intensive
Pre-wash (50 °C)
Wash (65 °C)
Rinse
Rinse
Rinse (65 °C)
Drying
4/16g
1 or 2 tabs
205 1.621 17.8
(*EN60436)
Prewash
Wash (45 °C)
Rinse (60 °C)
Drying
4/16g
1 or 2 tabs
230 0.923 11.0
Glass
Prewash
Wash(50 °C)
Rinse
Rinse(65 °C)
Drying
4/16g
1 tab
120 1.100 14.2
90 min
Wash(60 °C)
Rinse
Rinse(65 °C)
Drying
20g
1 tab
90 1.350 11.5
Rapid
Wash (50 °C)
Rinse
Rinse (45°C)
12g
1 or 2 tabs
30 0.751 11.2
NOTE
The ECO program is suitable to clean normally soiled
tableware, that for this use, it is the most efficient program
in terms of its combined energy and water consumption,
and it is used to assess compliance with the EU ecodesign
legislation.
Push latch to open
Eco
90
’