25
Installing the remote control battery
Remove the plastic film from the battery compartment.
1.
Push the release button inwards and pull the battery casing out. Remove the dead
battery.
2.
Insert 1x 3 V CR2025 battery, whilst making sure to respect the polarities (+ and -)
indicated on the casing.
3.
Slide the battery casing back into the remote control until you hear it click firmly
into place.
4. The remote control is now ready to use.
WARNING! Remove the batteries whenever you do not plan on using the remote
control for a long period of time.
Operation
WARNING! Before switching on the unit, make sure that it has been kept in an
upright position for at least 6 hours.
Switching the unit on/off
• Connect the plug to a mains socket. The unit will beep and the current temperature will
be displayed.
•
Press the button to turn on the unit. The FAN mode (the default mode) will start at
low speed. The fan and low speed indicators will light up and the current temperature
will be displayed.
• Press the button again to switch off the unit.
• Unplug the unit from the mains socket to completely switch it off.
Selecting a mode
1.
Press the unit’s button to select 1 of the 3 modes (the corresponding indicator will
light up):
Mode indicator Description
Cool (Air Conditioner) •
Cools the air temperature to the set temperature (16°C to
31°C).
•
All this mode’s functions can be selected: temperature, speed
and timer.
IMPORTANT: The drain hose must be connected to expel the
hot air outside.
Product usage
B
To Next Page
