8
EN
Using the appliance
B
Connect the new water inlet hoses to a ¾" threaded tap.
• Connect the white end of the water inlet hose to the white water inlet valve located at the
rear of the machine and the red end of the hose to the red water inlet valve (if available).
• Tighten the connections by hand. If in doubt, consult a qualied plumber.
• A water pressure between 0.1 and 1 MPa is required for optimum operating efciency
(a pressure of 0.1 MPa corresponds to a ow rate of more than 8 L of water per minute
with a fully open tap).
Once all the connections have been made, carefully turn on the water supply and check
for any leaks.
Make sure that the new water inlet hose is not pinched, twisted, bent, kinked or crushed.
• If the machine is tted with a hot water inlet connection, the temperature of the water
supplied must not exceed 70°C.
NOTE
The appliance must be connected to the water supply
network using the new connection sets supplied with
the appliance; used connection sets must not be
reused.
~ 95 cm
~ 145 cm
~ 95 cm
~ 140 cm
~ 95 cm
~ 150 cm
0 – max. 100 cm
To Next Page
Loading...
