8 EN
4.
To ensure safety and reduce noise, you should install the transportation bolt cover supplied
with the unit (see the annex accompanying the unit). Lean and place the transportation
bolt into hole and press it following the shown direction until it clicks.
Important: Keep the transport bolts and the wrench for future transporting of the
appliance and in this case refit the transport bolts in reverse order.
Adjustment of the feet
The appliance must be installed on a solid and level floor surface (if necessary use a spirit
level). If the appliance is to be installed on a wooden floor, distribute the weight by placing it on
a 60x60cm sheet of plywood at least 3cm in thickness and secure it to the floor. If the floor is
uneven, adjust the 4 leveling feet as required; do not insert pieces of wood etc. under the feet.
1. Slacken the locknut clockwise (see arrow) using the wrench.
2. Lift the machine slightly and adjust the height of the foot by revolving it.
Lower
Higher
Important: tighten the locknut by turning it anti-clockwise towards the appliance
casing.
Product usage
B
To Next Page
Loading...
Need help?
General