Issue 2

1 947199

V-2000A

INTEGRATED SINGLE ZONE PAGE CONTROL UNIT

INTRODUCTION

The V-2000A is an Integrated Single Zone Page

Control Unit for use with any electronic key or PABX.

The control unit provides external power (12 Valcom

power units) for powering Valcom One-way Amplified

Speakers.

These instructions contain the specifications and

information necessary to install, operate and maintain

the Integrated Single Zone Paging Control Unit.

"WARNING: To reduce the risk of fire or

electric shock, do not expose this appliance to

rain or moisture."

"WARNING: Shock Hazard - Do Not Open."

"AVIS: Risque de Choc Electrique ne pas

Ouvrir."

"PELIGRO: Corriente Elecrica - No Abra."

SPECIFICATIONS

Purpose

• Provides telephone system access to a single

zone of one-way paging

Applications

• Electronic Key Systems

• PABXs

• 1A2 Key Systems (400 type line card required)

• Stand Alone Systems

Refer to Figure 1 for a block diagram of a typical

installation.

Features

• Electronic key system line key access

• PABX loop start trunk port access

• Page port access

• Switchable battery feed for loop start operation

• RJ11 for Tip and Ring connections

• Power on LED

• Drives up to 150 Valcom one-way amplified

speaker assemblies (Audio)

• Background music input

• Voice operated switch to mute music during page

• Screw terminals provided for all connections

• UL Listed

• Supplies 12 Valcom power units for powering

Valcom one-way amplified speakers

• May be used with 25 or 70 Volt amplifiers

• AC powered

• AC input fused at 0.5 Amp

Capacity

• The V-2000A is a one-zone single talkpath unit.

• Each V-2000A will drive up to 150 Valcom

one-way amplified speaker assemblies (Audio)

and provides 12 Valcom power units for powering

the speaker amplifier assemblies. The V-2000A

can also be used to access 25 or 75 Volt

conventional amplifiers.

Valcom V-2000A - Page 2

Other manuals for Valcom V-2000A

Related product manuals