Do you have a question about the Valcom V-2001 and is the answer not in the manual?
Power Supply | 24V DC |
---|---|
Input Voltage | 24V DC |
Channels | 1 |
Voltage | 24V DC |
Output | 600 Ohm |
Type | One-Way Paging Control Unit |
Provides telephone system access to a single zone of one-way paging.
Lists compatible telephone systems like Electronic Key Systems, PABX, and 1A2 Key Systems.
Specifies input impedance as 600 ohms.
Notes input level as -10dbm nominal.
States voice switch sensitivity is -21 dbm.
Defines music input impedance range as 8 to 600 ohms.
Specifies music input level as -10dbm nominal.
Defines output impedance as 8 ohms.
Notes output level as -10dbm nominal.
Specifies -24VDC at 1 amp DC output.
Indicates voltage requirement is 120 VAC.
States current requirement is 1 Amp.
Notes maximum power requirement as 120 watts.
Explains unit provides paging access from PABX, EKS, or 1A2 Key System C.O. line.
Details required equipment for accessing the V-2001 via EKS or PABX.
Outlines equipment needed for V-2001 access via a telephone system page port.
Highlights safety precautions and warnings for installation.
Provides instructions and recommendations for mounting the unit securely.
Explains how to connect the unit's power cord to an AC wall socket.
Describes the location and function of volume controls for music and tones.
Details wiring for EKS or PABX trunk access.
Provides wiring steps for telephone system page port connections.
Explains how to connect a music source to the unit.
Details connecting telephone system ring signals for audible alerts.
Describes connecting a device for single tone alerts.
Explains general operation principles and voice switching behavior.
Provides a chart and contact information for resolving issues.