Valeo THERMO DC 200 User Manual

Rev. 05/2020
Id.No. 11118910E
Installation and operating instructions
THERMO DC 200
Bus
HEATING SYSTEMS

Valeo THERMO DC 200 Specifications

General

Brand	Valeo
Model	THERMO DC 200
Category	Heating System
Language	English

Summary

1 Statutory regulations governing installation

1.1 Statutory regulations governing installation

Details compliance with ECE Regulations R10, R122, and R100 for heater installation.

5.3 Installation Requirements for Combustion Heaters and Electrical Heaters into Vehicles

Specifies installation requirements based on ECE Regulation R122, Part I, for heaters.

2 Safety regulations

4 Operating and maintenance instructions

5 Installation

5.1. Additional potential equalization (PE)

Details the grounding procedure using a potential equalization screw and ring cable lug.

5.2. 690 VDC supply line

Instructions for connecting the 690 VDC power supply, emphasizing correct polarity and dedicated circuit.

5.3. Overcurrent protection / insulation monitoring device

Explains requirements for overcurrent protection devices and insulation monitoring for safe operation.

5.4. External power supply hook-up

5.5. Testing the installation

6 Maintenance

7 Faults, troubleshooting, repairs

8 Control elements

11 Installation of the heater - fitting of important assemblies

11.1. Installation

General installation guidelines, legal regulations, and precautions for the heating appliance.

11.2. Connection to the vehicle's cooling system

11.4. Tightening torques

12 Technical data