Valeo Thermo plus 160 User Manual (English)

Other manuals for Valeo Thermo plus 160

Operating And Service Instructions8 pages

Workshop Manual65 pages

Questions and Answers:

P
Paul GoldenAug 12, 2025
What to do if Valeo Heater has no fuel delivery?
- P
  Paul FritzAug 12, 2025
  If there's no fuel delivery to the Valeo Heater, check the fuel delivery to the heater. Possible causes include an empty fuel tank; bent, closed, clogged, or leaking lines; paraffin deposits or frozen water in fuel lines; a closed venting opening in the tank; mixed-up fuel lines; a contaminated fuel filter or screen in the pump; a defective fuel pump or coupling; or fuel lines that aren't vacuum-tight.
C
Curtis ValdezAug 22, 2025
Why Valeo Heater CO value cannot be adjusted?
- B
  Brenda SilvaAug 22, 2025
  If the CO value of the Valeo Heater cannot be adjusted to the nominal value, and there's irregular combustion, adjust the CO value to the nominal value. Possible causes include air bubbles in the fuel supply line (leaking fuel supply line), a contaminated or leaking fuel filter, a leaking fuel integration (suction lift, low pressure in tank), a defective fuel pump, a contaminated screen in the fuel pump, an ineffective O-ring seal on the fuel pump, a defective atomizer nozzle, throttled or closed combustion air and exhaust lines, a burner motor speed that is too low, or a defective coupling.
V
Virginia HarrisAug 31, 2025
What to do if the circulating pump of Valeo Aquavent 6000S does not operate?
- E
  esmithAug 31, 2025
  If the circulating pump of your Valeo Aquavent 6000S or 6000SC doesn't operate, it might be due to an activated error mode. In case of malfunctions, the motor is switched off via the error mode. Reactivate the circulating pump motor by disconnecting the power supply for more than 2 minutes. After reconnecting the power supply, the motor will perform a soft start.