What to do if nothing is shown on the display of my Valko Kitchen Appliances?
If nothing is displayed on your Valko Kitchen Appliances, there are several potential causes: * The main switch may be OFF. Turn the main switch ON. * The plug may not be properly inserted into the socket. Ensure the plug is securely plugged in. * The cable may be damaged. Inspect the cable and replace it if necessary.
Why the pump does not work in my Valko FAVOLA 315/06 Kitchen Appliances?
If the pump isn't working on your Valko Kitchen Appliances, consider these possibilities: * The oil may be spoiled. Check the pump oil and replace it if needed. * The room temperature might be too low (below 12°C). Move the equipment to a room with a temperature above 12°C. * The electrical connection could be incorrect. Ensure the equipment is connected with the correct cable section (see REPLACING OF THE CONNECTING CABLE).
What to do if the VAC LED flashes and the alarm sounds on my Valko FAVOLA 315/06 Kitchen Appliances?
If the VAC LED flashes and the alarm sounds on your Valko Kitchen Appliances, it indicates that the desired vacuum hasn't been achieved. Make sure that the lid gasket seats properly. Also, check if the lid gasket is damaged and replace it if necessary. Inspect the chamber edges and clean them if needed.
How to fix a Valko Kitchen Appliances bar that does not seal?
If the bar on your Valko Kitchen Appliances isn't sealing, it could be due to the sealing time not being long enough. Try resetting the sealing time. Another possibility is that the electrical terminals of the sealing bar are not connected; ensure these terminals are properly connected.
What does it mean when the GAS led flashes and the alarm sounds on my Valko Kitchen Appliances?
If the GAS LED is flashing and the alarm is sounding on your Valko Kitchen Appliances, it could indicate that the gas bottle is not connected. Ensure the gas bottle is properly connected. Alternatively, the gas pressure might be lower than 1 bar. Increase the gas pressure to 1 bar, but do not exceed 3 bar for correct machine operation.
Why does my Valko FAVOLA 315/06 machine cycle stop at 97%?
If your Valko Kitchen Appliances machine cycle stops at 97%, it could be due to the humidity of the air, which happens rarely. Try placing the equipment in a dry environment. You can also reduce the vacuum down to 97% or proceed with manual sealing by pressing the STOP key.
General| Brand | Valko |
|---|---|
| Model | FAVOLA 315/06 |
| Category | Kitchen Appliances |
| Language | English |
To Next Page