Fitting the batteries to the Remote Control Handset.
The remote control handset uses 2 x 1.5V
AAA type batteries. For longer battery life use
only alkaline batteries. To install the batteries,
slide the cover down on the rear of the
handset and remove (See figure 2). The
polarity of the batteries is marked on the
inside of the battery compartment.
If the heater does not respond to the remote
control handset commands, it is likely that the
batteries are faulty or require replacement.
Figure 2. Battery cover removal
© Baxi Heating U.K. Limited 2008.
INSTALLER AND OWNER GUIDE
Page 8
To Next Page
Loading...