Valtra A95 User Manual

19
Model Code Page
21. Engine
1. 12. 1986
205--555 210 1
Contents
General (Op. no. 210):
Specifications 2...................................................................
Special tools 7....................................................................
Engine, description 11..............................................................
Repair instructions
Cylinder block and flywheel housing (Op. no. 211):
1. Cylinder block and cylinder liners:
A. Measuring cylinder liner wear 1...................................................
B. Removing cylinder liners 1........................................................
C. Checking cylinder block 1........................................................
D. Changing camshaft bushing 1....................................................
E. Oversize bushings for camshaft 2.................................................
F. Fitting plug at rear end of camshaft 2...............................................
G. Fitting pipe for oil dipstick 2......................................................
H. Fitting cylinder liners 3...........................................................
2. Flywheel housing:
A. Fitting flywheel housing 4........................................................
B. Changing crankshaft rear oil seal 4................................................
Cylinder head and valve mechanism (Op. no. 212):
1. Cylinder head:
A. Removing cylinder head 1........................................................
B. R emoving valves 1..............................................................
C. Checking cylinder head 1........................................................
D . Changing valve guides 2.........................................................
E. Changing copper sleeve for injector 3..............................................
F. Machining valve seat 4...........................................................
G. Grinding valves 4...............................................................
H. Fitting valves 4.................................................................
I. Fitting cylinder head 4............................................................
2.Valve mechanism:
A. Reconditioning rocker arm mechanism 5...........................................
B. Changing camshaft/camshaft gear 6...............................................
C. Adjusting valve clearance 6.......................................................
Crank mechanism (Op. no. 213):
1. Crankshaft:
A. Removing crankshaft 1..........................................................
B. Checking crankshaft 1...........................................................
C. Changing crankshaft gears 1.....................................................
D . Fitting crankshaft 2..............................................................
2. Connecting rods and pistons:
A. Removing piston together with connecting rod 2.....................................
B. Changing connecting rod bearings 3...............................................
C. Checking connecting rod 3.......................................................

Valtra A95 Specifications

General

Engine Power	95 hp
Engine Cylinders	4
Displacement	4.4 liters
Hydraulic System	Open center
PTO Speed	540/1000 rpm
Rated Engine Power	95 hp
Cab	Available with or without cab