Valtra A95 User Manual

28
Model Code Page
21. Engine
205-- 555 210 8
1. 7. 1989
10. 1. 1992
14. 8360 97435 Milling cutter for facing exhaust and inlet valve seat(505---905)
15. 8360 97436 Milling cutter for exhaust and inlet valve seat (505---905)
16. 8360 97437 Inner milling cutter for exhaust and inlet valve seat (505---905)
17. 8361 97468 Drift for fitting 16 mm cap plug (505---905)
18. 7314 03506 Drift for fitting 36 mm cap plug (505---905)
19. 8360 97327 Puller for crankshaft gear (505---905)
20. 9025 79200 Holder for dial gauge (505---905)
21. 9025 78100 Press tool for cylinder liner (505---905)
22. 9025 98900 Drift for fitting dust cover, crankshaft front seal (505---905)
23. 9051 40200 Drift for fitting coolant pump seal (505---905)
24. 9025 98800 Drift for fitting tubular pin in timing gear casing (505---905)
25. 9025 98700 Drift for fitting tubular pin in timing gear casing (505---905)
26. 9051 73100* Puller for cylinder liner
26A. 8365 39293 Puller flange, 205, 305, 405
26B. 8353 39292 Puller flange, 355, 455, 555
27. 9051 72900* Milling cutter for fitting cylinder liner, 205, 305, 405
27A. 9051 72800 Milling cutter for fitting cylinder liner, 355, 455, 555
28. 9051 71300* Puller for injector
Locally prepared tools
29. 9051 64900 Drift for fitting coolant pump shaft (505---905)
30. ET(893 760) Support between front end and front axle to prevent oscillation
1
2
345
6
7
8
9
10

Valtra A95 Specifications

General

Engine Power	95 hp
Engine Cylinders	4
Displacement	4.4 liters
Hydraulic System	Open center
PTO Speed	540/1000 rpm
Rated Engine Power	95 hp
Cab	Available with or without cab