To Next Page
J
Jerry OlsonAug 16, 2025
What to do if my Vanguard 25E300 Engine is overheating?
- SScott RodriguezAug 16, 2025
If your Vanguard Engine shows an 'Engine Over Temperature' error, start by cleaning the engine cooling system components.
What to do if my Vanguard 25E300 Engine is overheating?
If your Vanguard Engine shows an 'Engine Over Temperature' error, start by cleaning the engine cooling system components.
How to fix a low oil level error on a Vanguard 25E300 Engine?
If the Vanguard Engine displays a 'Low Oil Level Error', refill the engine with new oil to the correct level. Then, start the engine to confirm the repair.
Why does my Vanguard 25E300 Engine detect vapors in FDI during RUN state?
If the Vanguard Engine detects vapors in FDI during the RUN state, it is likely due to high Reid Vapor Pressure (RVP) fuel in high-temperature environments. The solution is to drain the old fuel and replace it with new fuel.
What to do if my Vanguard 25E300 Engine detects vapors in FDI during CRANKING state?
If the Vanguard Engine detects vapors in FDI during CRANKING, this is likely due to high Reid Vapor Pressure (RVP) fuel in high-temperature environments. You should drain the fuel and replace it with new fuel.
How to troubleshoot engine overspeed detection on a Vanguard 25E300 Engine?
If the Vanguard Engine is overspeeding, check that the top no-load engine speed is operating at the intended speed. If the problem continues, inspect the intake system for leaks and repair or replace components as needed.
What causes a high voltage/open error on a Vanguard 25E300?
If the Vanguard Engine shows a 'Voltage High/Open' error, the EHT sensor might be faulty. Replace the EFI wire harness. Note that the EHT sensor is part of the EFI wire harness and cannot be purchased separately.
What causes a low voltage error on a Vanguard Engine?
If the Vanguard Engine displays a 'Voltage Low' error, the EHT sensor may be defective. Replace the EFI wire harness. Keep in mind that the EHT sensor is an integral part of the EFI wire harness and is not available separately.
What to do if Vanguard Engine shows 'Voltage Low' error?
If the Vanguard Engine displays a 'Voltage Low' error (SPN 158, FMI 4), you should charge or replace the battery.
What to do if Vanguard 25E300 has low voltage (SPN 168)?
If the Vanguard Engine displays a 'Voltage Low' error (SPN 168, FMI 4), you should charge or replace the battery.
General
