8
Instructions
Warning: To avoid risk of burns or injury, make sure to only
adjust the nozzle when the device is off.
BEFORE USING EVINA
Only fill Evina with distilled water. Tap water can cause the
buildup of limescale in the device and shorten its lifespan. Also,
don’t use any oils, herbs, etc. instead of water.
• First, remove the tank and unscrew the plug.
• Then, slowly and carefully pour the distilled water into the
tank until it reaches the “Min.” level but no higher than the
“Full” mark. At the “Full” mark, there will be enough water for
one, 15-minute session. Once filled, close the water tank and
fasten the plug.
• Last, insert the water tank back into Evina until it
clicks into place.
• Wash your face before using Evina. This will make the
detoxifying session even more eective.
• Then, adjust the nozzle to the height you’d like.
• For a full spa experience, soak the basket’s foam portion
with your favorite essential oil and place it on the device’s
nozzle. (There are three baskets included to prevent the
mixing of oils).
To Next Page
Loading...
